Operation 4
Selector Work Flow
Agilent Gas Sample Selector for 8860 and 8890 User Manual 59
Selector Work Flow
1 Connect the samples to the selector. Note the numbered position for
each sample.
2 For sample bags: If needed, use the sampling mode from Maintenance
operation to prepare the Selector. See Sampling mode for more details.
3 Create a sequence. Use the sample position as the vial number in the sequence,
and choose Selector as the injection source.
4 Run the sequence.
5 Remove the samples from the selector.
6 Use a maintenance mode as needed to purge the Selector of residual sample.
To Next Page
Loading...
