8 Agilent Gas Sample Selector for 8860 and 8890 Safety and Installation Manual
1 Safety Information
Safety and regulatory information
Safety and regulatory information
The Agilent G3451A Gas Sample Selector conforms to the following safety
standards:
• Canadian Standards Association (CSA): C22.2 No. 61010-1
• CSA/Nationally Recognized Test Laboratory (NRTL): ANSI/UL 61010-1
• International Electrotechnical Commission (IEC): 61010–1, 61010-2-081
• EuroNorm (EN): 61010–1
The Agilent Gas Sample Selector conforms to the following regulations on
electromagnetic compatibility.
• CISPR 11/EN 55011: Group 1, Class A
• IEC/EN 61326-1
NOTE
The Gas Sample Selector is designed and manufactured under a quality system
registered to ISO 9001. Declaration of Conformity available.
The Gas Sample Selector meets the following IEC (International Electro-technical
Commission) classifications:
• Safety Class 1
• Transient Overvoltage Category II
• Pollution Degree 2
This unit has been designed and tested in accordance with recognized safety
standards and is designed for use indoors in nonclassified locations. Do not
operate it in an explosive atmosphere. If the instrument is used in a manner not
specified by the manufacturer, the protection provided by the instrument may be
impaired. Whenever the safety protection of the Gas Sample Selector has been
compromised, disconnect the unit from all power sources and secure the unit
against unintended operation. Refer servicing to qualified service personnel.
Substituting parts or performing any unauthorized modification to the instrument
may result in a safety hazard.
To Next Page
Loading...
Need help?
General
