Agilent B1500 VXIplug&play Driver User’s Guide, Edition 3 2-49
Driver Functions
agb1500_setCv
Syntax ViStatus _VI_FUNC agb1500_setCmuInteg(ViSession vi, ViInt32 mode,
ViInt32 value);
Parameters vi Instrument handle returned from agb1500_init( ).
mode Integration/averaging mode. 0 (auto) or 2 (PLC).
value Coefficient for a reference value to set the integration time or
number of averaging samples. 1 to 1023 for auto mode, or 1 to
100 for PLC mode.
The reference value depends on the mode settings:
• For auto mode:
The reference value is the number of averaging samples that
is automatically set by the B1500. You cannot change it.
• For PLC mode:
The reference value is the averaging time (1/power line
frequency).
agb1500_setCv
This function specifies staircase sweep voltage source and sets the parameters. The
sweep source is used for the CV sweep measurement.
Syntax ViStatus _VI_FUNC agb1500_setCv(ViSession vi, ViInt32 channel, ViInt32 mode,
ViReal64 start, ViReal64 stop, ViInt32 point, ViReal64 hold, ViReal64 delay,
ViReal64 s_delay);
Parameters vi Instrument handle returned from agb1500_init( ).
channel Slot number of the slot that installs the MFCMU to be used. See
Table 2-2. channel=-1 detects the slot automatically.
mode Source output mode. 1, 2, 3, or 4. For the log sweep mode, start
and stop must be the same polarity.
1: Single-Linear sweep
2: Single-Log sweep
3: Double-Linear sweep
4: Double-Log sweep
start, stop Start or stop voltage (in V). Numeric expression. start and stop
must have the same polarity for log sweep.
0 (initial setting) to ±100 V
To Next Page
Loading...
Need help?
General
