Chapter 2 Quick Start
To prepare the power supply for use
25
22
To prepare the power supply for use
The following steps help you verify that the power supply is ready for use.
1 Check the list of supplied items.
Verify that you have received the following items with your power supply. If anything
is missing, contact your nearest Agilent Technologies Sales Office.
One appropriate power cord for your location.
One User's Guide.
This Service Guide.
Certificate of Calibration.
2 Verify that the correct power-line voltage setting is selected and that the correct
power-line fuse is installed.
The line voltage is set to 100, 115 or 230 Vac from the factory according to the input
power option selected when you ordered the power supply. Change the voltage setting
if it is not correct for your location (see the next page for detailed information). For
100 or 115 Vac operation, the correct fuse is 2.5 AT (Agilent part number 2110-0913)
and for 230 Vac operation, the correct fuse is 2 AT (Agilent part number 2110-0587).
3 Connect the power cord and turn on the power supply.
A power-on self-test occurs automatically when you turn on the power supply. The
front-panel display will light up while the power supply performs its power-on self-
test. After performing the self-test, the power supply will go into the power-on / reset
state; all outputs are disabled (the OFF annunciator turns on); the display is selected
for the +6V supply (the +6V annunciator turns on); the knob is selected for voltage
control.
4 Enable the outputs
Press the key to enable the outputs. The OFF annunciator turns off
and the +6V and CV annunciators are lit. The blinking digit can be adjusted by turning
the knob. Notice that the display is in the meter mode. "Meter mode" means that the
display shows the actual output voltage and current.
To Next Page
Loading...
Need help?
General
