Agilent Technologies E3631A Service Guide

Chapter 3 Calibration Procedures
Aborting a Calibration in Progress
75
3
Aborting a Calibration in Progress
Sometimes it may be necessary to abort a calibration after the procedure has already
been initiated. You can abort a calibration at any time by turning the power supply
off from the front panel. When performing a calibration from the remote interface,
you can abort a calibration by issuing a remote interface device clear message or by
pressing the front-panel "Local" key.

Agilent Technologies E3631A Specifications

General

Brand	Agilent Technologies
Model	E3631A
Category	Power Supply
Language	English