4-28 Chapter4
Troubleshooting
–399 to –300: Device-Specific Error Messages
–399 to –300:
Device-Specific Error Messages
An error number in the range [−399 to −300] indicates that the
instrument has detected an error where some device operations did not
properly complete, possibly due to an abnormal hardware or firmware
condition. This is not a error in response to a SCPI query or command,
or command execution. The occurrence of any error in this class will
cause the device-specific error bit (bit 3) in the event status register to
be set.
Device-Specific Error Message Descriptions
(Number) Description
(-310) System error
Indicates that an error, termed “system error” by the
device, has occurred.
(-300) Device-specific error
This is a generic device-dependent error for devices
that cannot detect more specific errors. The code
indicates only that a device-dependent error as defined
in IEEE 488.2, 11.5.1.1.6 has occurred.
To Next Page
Loading...
Need help?
General
