1200 Series DAD and MWD User Manual 49
Using the Detector 4
Preparing the HPLC System
1 Turn on the Agilent ChemStation PC and the monitor.
2 Turn on the 1200 series HPLC modules.
3 Start the Agilent ChemStation software (B.02.01). If the pump,
autosampler, thermostatted column compartment and detector are found,
the ChemStation screen should look like shown in
Figure 8.
The System status is red (Not Ready).
Figure 8 Initial ChemStation screen (Method and Run Control)
On-line plot window details window
System status
To Next Page
Loading...
