52
Order online at www
.agilent.com/chem/store
Capillary Column Ferrules
Ferrule ID (mm) Column ID (mm) Unit Part No.
General Purpose Graphite Ferrules (Short)
0.5 0.1, 0.2, 0.25, 0.32 10/pk 5080-8853
0.4 0.05, 0.25 10/pk 500-2114
0.8 0.45, 0.53 10/pk 500-2118
1.0 0.53 10/pk 5080-8773
85% Vespel, 15% Graphite Ferrules (Short)
0.4 0.1, 0.2, 0.25 10/pk 5181-3323
0.5 0.32 10/pk 5062-3514
0.8 0.45, 0.53 10/pk 5062-3512
Preconditioned 85% Vespel, 15% Graphite Ferrules (Long)*
0.3 0.1 10/pk 5062-3507
0.4 0.1, 0.2, 0.25 10/pk 5062-3508
0.5 0.32 10/pk 5062-3506
0.8 0.53 10/pk 5062-3538
100% Vespel, High Performance Ferrules (Short)**
0.4 0.1, 0.2, 0.25 10/pk 5181-3322
0.5 0.32 10/pk 5062-3513
0.8 0.45, 0.53 10/pk 5062-3511
Specialty Ferrules, 85% Vespel, 15% Graphite
Two Hole
0.4 0.1, 0.2, 0.25 10/pk 5062-3580
0.5 0.32 10/pk 5062-3581
No hole 10/pk 5181-3308
High Temp PTV Inlet, SS/Graphite
0.4 0.320 10/pk 5188-5315
0.4 0.530 10/pk 5188-5314
*These ferrules are recommended for use with Agilent GC/MS Transferlines with the 05988-20066 MS
interface column nut.
**These ferrules are recommended for use in isothermal analysis only.
Tips & Tools
100% Vespel ferrules should only be
used for isothermal applications.
Graphite ferrules, 5080-8853
To Next Page
Loading...
