Agilent InfinityLab LC Series 1260 Infinity II Isocratic- and Quaternary Pumps User Manual 243
LAN Configuration
12
Manual Configuration
2 Type the following at the system (DOS) prompt:
• c:\>telnet <IP address> or
• c:\>telnet <host name>
Figure 30 Telnet - Starting a session
where <IP address> may be the assigned address from a Bootp cycle, a
configuration session with the Handheld Controller, or the default IP
address (see “Configuration Switches” on page 236).
When the connection was established successfully, the module responds
with the following:
Figure 31 A connection to the module is made
To Next Page
Loading...
