Installation Note E4440-90613 7
Switchable Microwave Preselector Bypass Installation Kit
Tools Required
❏ T-8 Torx driver
❏ T-10 Torx driver
❏ T-20 Torx driver
❏ 9/16-inch open end wrench
❏ 9/16-inch nut driver
❏ tweezers
❏ 1/4-inch deep socket driver (for instruments with Option AYZ
❏ Calibration software. Latest software information and downloads available at
http://www.agilent.com/find/calibrationsoftware
❏ Test equipment supported by the calibration software.
❏ PSA Series Spectrum Analyzer and Service Guide. This manual is available as part of
the E4446AU, E4447AU, or E4448AU Option OBW kits.
❏ Microsoft® Windows® based personnel computer using LAN connection and
CD-ROM drive.
❏ GPIB Interface. Agilent 82350B or 82357B. National Instruments PCI-GPIB or
GPIB-USB-HS
❏ Windows 2000® (Service Pack 4), Windows XP® (Service Pack 2)
❏ Crossover cable if PC or analyzer is not connected to network. Use a CAT, RJ45 cable
with cross pinning, Agilent p/n 8121-0545
❏ Firmware A.0 9.10 or later. Download the latest revision form
http://www.agilent.com/find/psa_firmware, or order the Firmware Update kit.
Depending on your model number, the firmware update kit is ordered as: Order
E444xAU (Qty.1) Option UE2 (Qty. 1), where the “x” is the last digit of the model
number. For example: E4440AU option UE2.
Microsoft®, Windows®, and Windows XP® are US registered trademarks of Microsoft Corporation.
To Next Page
Loading...
Need help?
General
