Instructions for Use 16
Turbo-V 81-M User Manual / 87-900-983-01 (E) 185/228
General Information
This equipment is destined for use by professionals. The user should
read this instruction manual and any other additional information
supplied by Agilent before operating the equipment. Agilent will not
be held responsible for any events occurring due to non-compliance,
even partial, with these instructions, improper use by untrained
persons, non-authorized interference with the equipment or any
action contrary to that provided for by specific national standards.
The Turbo-V 81-M is a turbo-molecular pump for high and ultra-high
vacuum applications which can pump any type of non-corrosive gas
or gas compound. It is not suitable for pumping liquids or solid
particles.
The pumping action is obtained through a high speed turbine (max.
80000 rpm) driven by a high-performance 3-phase electric motor. The
Turbo-V 81-M is free of contaminating agents and, therefore, is
suitable for applications requiring a "clean" vacuum.
The following paragraphs contain all the information necessary to
guarantee the safety of the operator when using the equipment.
Detailed information is supplied in the appendix "Technical
Information".
This manual uses the following standard protocol:
WARNING!
The warning messages are for attracting the attention of the operator to a
particular procedure or practice which, if not followed correctly, could lead to
serious injury.
CAUTION!
The caution messages are displayed before procedures which, if not followed,
could cause damage to the equipment.
NOTE
The notes contain important information taken from the text.
To Next Page
Loading...
Need help?
General
