xii U2000 Series Operating and Service Guide
2 Operating Information
Measurement Mode 22
• Average only Mode 22
• Normal Mode 22
Power Sensor Configuration Settings 25
Measurement Accuracy and Speed 27
• Setting the Range 27
• Measurement Considerations 28
Internal and External Zeroing 30
Power Sweep and Frequency Sweep 32
Step Detection 33
Pulse Power Measurement in Average only Mode 34
3 Specifications and Characteristics
Introduction 36
Specifications 38
• Frequency and Power Ranges 38
• Connector Type 38
• Maximum SWR (25 °C ±10 °C) 39
• SWR Plots for U2000 Series USB Power Sensors 40
• Maximum SWR (0 °C to 55 °C) 45
• Maximum Power 47
• Power Accuracy 48
• Switching Point 51
• Zero Set, Zero Drift, and Measurement Noise 53
• Settling time 59
• Calibration Factor and Reflection Coefficient 61
• Cal Factor Uncertainty 62
• Trigger 65
• Normal Mode Key Specifications and Characteristics 66
General Characteristics 67
To Next Page
Loading...
Need help?
General
