Edition 02.97 Grassland Mower Hopper 5000 17
3. Devices and Operating Elements
The grassland mower AGRIA 5000 is
suited for horticultural, agricultural, and
forestal operations, for grass and park
maintenance and for winter service op-
eration. The following cutter bars are
available:
l
Cutter bar – Z
71 cm
91 cm
Engine
The four-stroke petrol engine runs on
commercial petrol (refer to fuel recom-
mendations p4).
During the first 20 operating hours
(break-in period) do not operate the
engine at maximum speed.
Even after the break-in period never
operate the engine at higher speed than
is necessary for the work in hand.
I
High engine speed is harm-
ful to any engine and consid-
erably affects its longevity.
This applies especially for no load
operation. Any overspeed (have the
engine roar) can result in immediate
damage.
Cooling System
The cooling system is fan-cooled. There-
fore keep the grille on the recoil starter
and the cooling fins on the cylinder clean
and free from sucked-in plant trash.
Always ensure that idling-speed is ad-
justed correctly. At low speeds and with
the speed control lever set to idle, the
engine is supposed to run smoothly and
without run-out.
Air Filter
The air filter purifies the air intake. A
clogged filter reduces engine output.
Ignition System
The engine is equipped with a mainte-
nance-free, contactless electronic igni-
tion system. We recommend to have
necessary check-ups done by an expert
only.