Aim MIL-STD-1553 - Page 483

MIL-STD-1553 Reference Manual
469
Appendix A – Document/Software History
Version
General or S/W Function
Change
Description
ApiCmdBCXferReadEx
Added
ApiCmdBMCapMode
Corrected description for parameter ‘cap_mode’ (value 2)
ApiCmdBMReadMsgFltRec
Corrected description for parameter ‘mode’
Corrected wrong reference in description for parameter ‘con’
Sub-chapters describing the message filter recording formats
were numbered wrong
Added new message filter recording format (format 4,
parameter ‘con’)
ApiCmdBMStackEntryFind
Added ‘padding1’ and ‘padding2’ to structure ‘pfnd’
ApiCmdBMStackEntryRead
Corrected purpose section
ApiCmdBMStackpRead
Added ‘padding1’ and ‘padding2’ to structure ‘pstackp’
ApiCmdBMStatusRead
Corrected description for parameter ‘bus_load_pri_avg’
ApiCmdBMTCBIni
Added ‘padding1’ to structure ‘ptcb’
ApiCmdBufDef
ApiCmdBufRead
ApiCmdBufWrite
Changed description for parameter “bid”
ApiCmdCalTransCon
Two notes concerning 500kHz Mode added
ApiCmdCalCplCon
Note changed for parameter cpl (coupling)
ApiCmdExecSys
Corrected note for parameter ‘mode’ (“2 seconds” instead of
“5 seconds”)
Note added for parameter ‘con’ (signal setting)
Extended description for parameter ‘con’ (when mode=8)
ApiCmdIni
Corrected description for parameter ‘board_config’
Extended description for parameter ‘chns’
Extended description for parameter ‘prot’
Corrected description for parameter ‘pbi_id_biu1’
Corrected description for parameter ‘pbi_id_biu2’
ApiCmdQueueRead
Corrected description for parameter ‘msg_trw’ (value 10)
 changed “too AiInt16” in “too short”
Corrected description for parameters ‘sa_mc’ and ‘sa_type’
Extended description for parameter ‘msg_trw’ (value 11)
Added new parameters ‘rt_addr2’, ‘sa_mc2’, ‘sa_type2’,
‘status_word1’ and ‘status_word2’ for
RTRT transfers
Removed parameter ‘padding1’
ApiCmdReset
Corrected prototype (function type “AiInt16” was missing)
ApiCmdRTBHDef
Changed description for parameter ‘bid’
Extended description for parameter ‘sqm’
Corrected “Return Value” section
ApiCmdRTDytagDef
Corrected name of parameter ‘rt_dytag’ (was ‘bc_dytag’)
ApiCmdRTEnaDis
Corrected description for parameter ‘con’
ApiCmdRTGetSAConErr
Corrected description for parameter ‘type’ (constants
API_ERR_TYPE_BIT_CNT_LOW and
API_ERR_TYPE_BIT_CNT_HIGH were swapped)
Extended description for parameter ‘contig’
ApiCmdRTGetSimulationInfo
Changed parameter ‘ul_HSMC[8]’ to ‘ul_HSMC’