CHAPTER 6
26 27
MXm
To complete this procedure use Race Studio 3 software as here explained. To obtain connectivity on the device the PC has to be authenticated to the same
network as shown here below.
When the PC is authenticated to the network called “AiM” it can see all devices you
configured to access the same network. In the image below two AiM devices are
connected to the same “AiM” WLAN.
Here above you see a device “MXm ID 6500100” that switched from AP to WLAN mode
(Existing Network).
Network name is “AiM” and does not work with free access because is protected by a
password
To Next Page
Loading...
