CHAPTER 6
24 25
MXm
This AP or SSID name is unique for your device.
An example of name is:” AiM-MXm-00100” where:
n
“AiM” is the prefix of all AiM devices
n
“MXm” is the device identifier
n
“00100” is your device serial number assigned by the factory.
To make your device more recognizable you can add a name to the SSID. The limit is
of eight characters. Allowed characters are all letters, capital too, all digits and these
characters: ‘+ - _ () [] {}!.
“Space” type can be used provided that it is not the first one because it can cause in-
comprehension in some WindowsTM versions.
If, for example, you add the driver’s name, Tom Wolf, the network name (SSID) beco-
mes:
”AiM-MXM-00100-TomWolf”
Once all parameters set click “Transmit”. MXm reboots and is configured with the new
parameters. If MXm is protected by a password, as recommended, Race Studio 3 will
ask that password to authenticate.
Please Note the same Wi-Fi connection can be created with the operative system
tool. Once the device has been authenticated in the Wi-Fi network you can
communicate with it using Race Studio 3.
This situation is ideal for a team with multiple drivers and staff members and is desired
to communicate with one or more AiM devices using the same PC network. Each
MXm can have its password that adds another security and privacy level to the net-
work.
Race Studio 3 will show all MXm connected to the same network under “Connected
devices” label, bottom left of the software page: click your device.
Enter “Wi-Fi and properties” tab and set it on “Existing Network”; fill in network name,
network password and device password.
Transmit the network settings to your device clicking “Transmit”: your device reboots
and joins that network.
Please note: the only admitted password are those following WPA2-PSK standard.
6.1.3 Adding MXm to an existing network
To Next Page
Loading...
