22
Introduction
4.3.3 Add a station
Use this flowchart to add a station.
1. Connect a PC to the station to be added.
Connect stations one at a time to avoid IP address conflict.
“Connecting to a PC (→page 44)”
2. Log in to the Web server of the added station using its IPv4 address (default value).
“Log in to the Web server of the station to be configured (→page 45)”
3. Set "Static / DHCP" to "Static IPv6" and configure "IPv6 Address."
“Static / DHCP (→page 66)”
The station will be restarted with the assigned IPv6 Address.
4. Log in to the Web server of the added station with IPv6 address.
“Log in to the Web server of the station to be configured (→page 45)”
5. Configure “Language (→page 63)”.
Click [Update] to update the settings.
6. Configure the station.
"Configuring the station" “Configuring the Station (→page 59)”
7. Add data to other stations and software if required.
8. Done.
To Next Page
Loading...
Need help?
General
