25
Introduction
4.4 For Stateless IPv6 Address
4.4.1 Create new data
Use this flowchart to create a new setting file, e.g., when installing a new system.
Support Tool is needed to configure the system using this flowchart. Install Support Tool, and set for IPv6. For set up
information, refer to "IX Support Tool Setting Manual."
Important
• Save the setting file after configuring the system. Refer to “Settings File Backup (→page 153)”.
• If the setting data is not saved, it may be impossible to restore it after maintenance or after-sales servicing.
1. Install a device (e.g., router) which can transmit RA (supports the stateless IPv6 setting).
Do not change the prefix of the device that can transmit Router Advertisement (RA). For how to set up the device,
2. Connect a PC to the station to be configured.
The default IP addresses of the stations are identical. Connect one at a time.
“Connecting to a PC (→page 44)”
3. With the default IPv4 Address, log in to the Web server of the station to be configured.
“Log in to the Web server of the station to be configured (→page 45)”
4. Set "Static / DHCP" to "IPv6 Stateless."
“Static / DHCP (→page 66)”
The station restarts and an IPv6 address is automatically configured. If the IP address fails to be automatically configured, it
will become "FDC2::7000." If this happens, cycle power to the station, and then the IP address will be automatically
reconfigured.
5. Configure other stations to be "IPv6 Stateless."
6. Search each station with Support Tool for its IPv6 address.
To Next Page
Loading...
Need help?
General
