34
Introduction
4.5.3 Add a station
Use this flowchart to add a station.
1. Configure the DHCP server to assign a static IP address.
The DUID of the station is "00030001 + MAC address."
For how to set up the DHCP server, refer to its manual.
2. Connect a PC to the station to be added.
Connect stations one at a time to avoid IP address conflict.
“Connecting to a PC (→page 44)”
3. With the default IPv4 Address, log in to the Web server of the station to be added.
“Log in to the Web server of the station to be configured (→page 45)”
4. Set "Static / DHCP" to "IPv6 DHCPv6."
“Static / DHCP (→page 66)”
The station restarts and the IPv6 address that is configured with the DHCP server beforehand is assigned. If the IP address
fails to be automatically configured, it will become "FDC2::7000." If this happens, cycle power to the station, and then the IP
address will be automatically reconfigured.
5. Log in to the Web server of the station with the assigned IP address.
“Log in to the Web server of the station to be configured (→page 45)”
6. Configure “Language (→page 63)”.
Click [Update] to update the settings.
7. Configure the station.
"Configuring the station" “Configuring the Station (→page 59)”
8. Add data to other stations and software if required.
9. Done.
To Next Page
Loading...
Need help?
General
