36
Introduction
4.5.5 Replace a station
Use this flowchart to replace a station.
1. Configure the DHCP server so that the new station installed inherits the IP address assigned
to the replaced station.
The DUID of the station is "00030001 + MAC address."
For how to set up the DHCP server, refer to its manual.
Can the Web server of the station to be replaced be accessed?
YES NO
2. Back up the setting file of the station to be
replaced.
“Settings File Backup (→page 153)”
2. Replace the station.
3. Replace the station. 3. Restore the stored setting file to the newly
installed station.
If the station setting file is modified after being stored, those
changes will not be reflected.
“Settings File Backup (→page 153)”
4. Restore the backup setting file to the newly
installed station.
“Settings File Backup (→page 153)”
5. Done. 4. Done.