46
How to use
Monitoring
3
Monitoring a door station
Video and audio of the following stations can be monitored.
• Entrance Station
• Door Stations that are registered in Outside Areas
• Door Stations that are registered in the same Unit
• Network Camera
For stations without cameras, only audio will be heard while monitoring.
Audio of the station that initiates monitoring cannot be heard by the other party during monitoring. However, the other
party may be notified that they are being monitored (a notification tone or flashing LED), depending on the
configuration of the other station.
If the station of the other party is in the following condition, monitoring cannot be performed.
• Outgoing call
• Incoming call
• Incoming page
• Communicating
• Set to refuse monitoring
1. Tap [Monitor] on the Home
screen.
2. Select a station to monitor.
• Refer to (→page 31) for how to search
stations.
3. Tap [MONITOR].
• The calling tone plays until monitoring begins.
4. View the video and audio.
• Refer to (page 60 and page 64 through
page 68) for operations during monitoring.
5. To end monitoring, tap .
To Next Page
Loading...
