36
How to use
Placing / Answering a Call
3
Use an external device to place a call
Use an external device (sensor, call button, etc.) to place a call to a pre-determined location.
1. Activate the external device
• The ringback tone will play from the speaker of
the station.
2. Speak when the other party
answers
• Lift the handset to switch to handset
communication.
• For how to view the screen during a call, refer
to (→page 18).
• Refer to (page 60 through page 69) for
operations during a call.
3. To end the communication, hang
up the handset or tap .
Call button, etc.
Input
Outgoing
Station
If the call button is connected
Note
• It may not be possible to place a call. It depends on the
configuration of the station.
• The call is placed using the priority that was set during
programming.
• The ringback tone may not be played, depending on the
settings.
• If the communication time set in advance is exceeded on
your station, communication automatically ends. A
notification tone sounds approximately 10 seconds before
ending. The notification tone may not sound depending on
the configuration.
• If a page with a higher priority is received from another
station while making an outgoing call or during a
communication, the outgoing call or call will be interrupted
and the station will switch to the page.
• Topping during communication turns off the
microphones of the handset and the station as well as
camera video. Tap to turn them back on.
• When receiving another call while talking, a notification
tone will be heard from the handset or built-in speaker. Tap
to choose the station to communicate with.
(→page 63)
To Next Page
Loading...
