Aiphone IXG System - Answering a Call

37
How to use
Placing / Answering a Call
3
Answering a call
When there is an incoming call, the status indicator flashes and the ringtone plays.
Video of the destination station is displayed, and it is able to communicate by answering the call.
1. When receiving a call, lift the
handset or tap .
Alternately,
• Refer to (→page 16) for how to view the
screen when receiving a call.
• Refer to (page 63, page 67, and page 70) for
operations when receiving a call.
2. Speak with the other party
• For how to view the screen during a call, refer
to (→page 18).
• Refer to (page 60 through page 69) for
operations during a call.
3. To end the communication, hang
up the handset or tap .
Note
• Depending on the configuration, the ringtone may be heard
from a separately installed speaker or other device.
• If the communication time set in advance is exceeded on
the station of the other party, communication automatically
ends. A notification tone sounds approximately 10 seconds
before ending. The notification tone may not sound
depending on the configuration.
• If a page with a higher priority is received from another
station during communication, the call will be interrupted
and the station will switch to the page.
• If a page or a call with a higher priority is received from
another station while receiving a call, the station will switch
to the page or call with a higher priority.
• The ringtone may not sound, depending on the
configuration.
• Topping during communication turns off the
microphones of the handset and the station as well as
camera video. Tap to turn them back on.
• When receiving two or more calls simultaneously, tap
to choose the station to communicate with.
(→page 63)
• When Auto Answer
(→page 80) is "ON," an individual call
from another Master Station will be answered
automatically. It will not automatically answer a group call
or a call from a Handset Sub Station or Door Station.
• Depending on the setting, if the electrical lock is released
during incoming calls from the Entrance Station or while
communicating, the incoming call or communication will
end automatically after approximately 10 seconds.