What to do if the room temperature is above 105°F for Air Techniques MOJAVE LT3 Medical Equipment?
If the room temperature exceeds 105°F, it is likely due to inadequate ventilation in the equipment room. Ensure the ambient temperature is not above 105°F and increase ventilation in the equipment room if needed.
What to do if the Separator is below minimum speed in Air Techniques MOJAVE LT3 Medical Equipment?
If the separator is below minimum speed, try the following: 1. If a large amount of liquid has entered the Separator, try turning the pump on again. 2. Check that the separator fan is spinning when the pump is turned on. 3. Verify the hall effect sensor cable is not loose at the back of the unit.
What to do if the vacuum level value is more than 1.0 inHg over setpoint in Air Techniques MOJAVE LT3 Medical Equipment?
If the vacuum level value is more than 1.0 inHg over the setpoint, check that the control board is not in 'Bypass' mode.
Why is the line voltage out of range for Air Techniques Medical Equipment?
The line voltage may be out of range due to voltage dips or spikes on the AC Mains, or if the unit is installed on a 120 VAC circuit. Ensure the pump is on a dedicated 220 VAC circuit.
How to fix high room temperature for Air Techniques Medical Equipment?
If the room temperature is too high, this could be caused by inadequate ventilation in the equipment room or restricted exhaust lines. Check that the ambient temperature is not above 105°F. Increase the ventilation in the equipment room if necessary. Also, check that the exhaust lines are not blocked or restricted.
What does it mean when a Motor VFD error is detected in Air Techniques MOJAVE LT3 Medical Equipment?
If a Motor VFD error is detected, check for the VFD error code under the 'Settings -> Info' screen.
What causes low room temperature for Air Techniques MOJAVE LT3 Medical Equipment?
If the room temperature is too low, it may be caused by inadequate insulation of the equipment room. Check that the ambient temperature in the equipment room is above 40°F. Increase heating to the equipment room if necessary.
Key safety precautions and warnings for unit operation.
Specifications for the electrical supply and wiring.
Specifications for plumbing connections and drain lines.
General instructions for connecting the LT3 unit.
Procedure for connecting the separator drain to the sewer.
How to connect the main 220V power supply to the pump.
How the system runs, standby mode, and remote operation.
Steps to start the unit using the LCD touch screen.
Explanation of the main power switch and circuit breaker.
Steps to start the unit using an optional remote switch.
How warnings and errors are displayed on the screen.
List of critical errors and their immediate actions.
List of specific conditions that trigger warnings.
Procedure using CleanStream Cleaner for daily maintenance.
Table of warnings, causes, and recommended solutions.
Table of errors, causes, and recommended solutions.
General| Model | MOJAVE LT3 |
|---|---|
| Manufacturer | Air Techniques |
| Frequency | 50/60 Hz |
| Air Dryer | No |
| Number of Users | 1 |
To Next Page
