Page 11
REcEivER cOnnEcTiOnS anD MOUnTing
l
We suggest Binding the transmitter and receiver, and setting the Throttle Fail Safe position, prior to mounting your receiver in
your model.
l
The receiver should be mounted as far away from any electrical components as possible.
l
Route the receiver antenna up through a plastic tube so that it is in the vertical position.
l
To protect the receiver from vibration and other damage, we recommend wrapping the receiver in shock absorbing foam when
installing it in your model.
WARNING The receiver is NOT equipped with BEC circuitry. DO NOT use a receiver battery any greater than 6.0 volts to
power the receiver. Use only a 4.8 volt to 6.0 volt receiver battery, an ESC with a BEC circuit that lowers the voltage to the
receiver, or a voltage regulator that lowers the voltage to the receiver.
Set your model on a stand so the wheels are off the ground before turning on your radio control system or connecting
your motor for the rst time.
waRningS iF USing a Li-PO OR Li-FE TRanSMiTTER BaTTERY
l
Use a 2 Cell Li-Po or Li-Fe battery pack of desired capacity.
or the transmitter will be damaged.
l
Do NOT charge your battery through the transmitter using the Charging Jack. The battery be removed from the
transmitter for charging or the transmitter could be damaged.
l
Use a charger specically designed to charge Li-Po or Li-Fe batteries.
l
When changing the connector on your battery to match the battery power plug in the base of the
transmitter, please observe correct polarity. Connecting with reverse polarity will damage the
transmitter.
l
Observe all safety precautions provided with your Li-Po or Li-Fe battery before and during use, and during the charging process.
l
Damage to the transmitter caused by improper use, wrong battery type, or reverse polarity will not be covered under warranty.
- = Negative (Black)
+ = Positive (Red)
Tx anD Rx OPTiOnS anD cOnnEcTiOnS
Use the diagram below to make the connections to your 92744 2.4GHz FHSS-3 receiver included with your radio control system.
The 92744 receiver's Nominal Input Voltage is 4.8v ~ 6.0v. A 2 cell Li-Po or 2 cell Li-Fe battery can be used to power the
receiver, however, a voltage regulator MUST be used. We recommend a switching type voltage regulator and it must be
able to handle the amperage demands of the servos used in your model.
If you're using an Electronic Speed Control with BEC circuitry, verify that it reduces the voltage down to 4.8v ~ 6.0v before
making your connections and turning your radio control system ON.
To Next Page
Loading...
