AJA FS1 - Screen Saver; Display Intensity; Serial Number; Software Version

1
73
FS1 Installation and Operation Manual — 70.1 Screen Saver
70.1 Screen Saver
When set to AJA Logo, a rolling AJA logo screen saver will appear on the alphanumeric
display after 60 minutes of inactivity—defined as no button presses on the front panel.
If disabled, the display just becomes dim. When the Screen Saver is on, the Status button
will return the display to the last Status display, or any Select or Adjust button will return
the display to the last parameter menu.
70.2 Display Intensity
This parameter determines the brightness of the alphanumeric display and front panel
LEDs.
80.1 Serial Number
This parameter displays the FS1’s unique serial number.
80.2 Software Version
This parameter displays the FS1’s software version level.
90.0 Reboot
This parameter reboots the FS1:
1. Use the Select buttons to scroll to parameter 90.0 Reboot.
2. Press the top Adjust button to advance to the [UP to Confirm] menu field. (Press
any other button to cancel.)
3. Press the top Adjust button again to advance to the [Both=Reboot] menu field.
4. Press both Adjust buttons at the same time to reboot.
The display shows [Rebooting], goes dark momentarily, and then shows the percentage
of progress as the system reboots. Rebooting takes a couple of minutes.
70.1 Screen Saver Description of Choices
Parameter Adjustments:
AJA Logo (Default)
System Name
Disabled
Display horizontally rolling AJA logo after 60 minutes of button inactivity.
Display the FS1 system name (defined in parameter 50.5).
Dim display after 60 minutes of button inactivity.
70.2 Display Intensity Description of Choices
Parameter Adjustments:
variable
Using the Adjust buttons, you can dim or brighten the alphanumeric display and
activity indicator LEDs in steps from 1 (dim) to 8 (brightest).
Default: 6