AJA FS1 - Factory Settings

1
75
FS1 Installation and Operation Manual — 99.0 Factory Settings
Additionally, editable parameters in the following list are not stored:
99.0 Factory Settings
Selecting this parameter and then pressing the Adjust (up) button recalls the FS1’s
factory default settings.
Caution: Selecting this parameter and recalling factory defaults will overwrite the
current settings (except for the settings listed below). Existing settings will be lost.
Recalling factory defaults using only the Adjust (up) button does not affect the
following parameter settings. To apply defaults to these parameters, hold down both
the Adjust (up) and Adjust (down) buttons at the same time.
Note: To set a single parameter to its factory default value, go to that parameter's
“Adjust” menu, and hold down both
the Adjust (up) and Adjust (down) buttons at the
same time.
• 35.1 Remote Control • 51.2 SNMP Trap Dest 1
• 35.3 Password • 51.3 SNMP TrapPort 1
• 40.1 Freeze Output • 51.4 SNMP Trap Dest 2
• 50.1 IP Config • 51.5 SNMP Trap Port 2
• 50.2 IP Address • 60.1 Pwr Supply Alarm
• 50.3 Subnet Mask • 60.2 Format Alarm
• 50.4 Default Gateway • 60.3 Reference Alarm
• 50.5 System Name • 70.1 Screen Saver
• 51.1 SNMP Enable • 70.2 Display Intens
• 35.3 Password • 51.4 SNMP Trap Dest 2
• 50.1 IP Config • 51.5 SNMP Trap Port 2
• 50.2 IP Address • 60.1 Pwr Supply Alarm
• 50.3 Subnet Mask • 60.2 Format Alarm
• 50.4 Default Gateway • 60.3 Reference Alarm
• 51.1 SNMP Enable • 70.1 Screen Saver
• 51.2 SNMP Trap Dest 1 • 70.2 Display Intens
• 51.3 SNMP TrapPort 1