Switches the keypad to the signal fade test mode (available in
devices with firmware version 3.50 and later)
Either a shared or personal password can be set on the keypad for each user.
In order to install a personal password:
1. Go to profile settings (Hub User settings Users Your profile settings)
2. Click “Access Code Settings” (in this menu you can also see the user identifier)
3. Set the User Code and Duress Code
Each user sets his own personal password individually!
To control the system using the personal password:
• Enter: User identifier * personal password Arming/disarming button
To Next Page
Loading...
Need help?
General
