For the detection and interfacing to occur, the device should be located within the coverage area of the wireless
network of the hub (at a single protected object). Request for connection to the hub is transmitted for a short time at
the time of switching on the device.
If the connection to Ajax hub failed, wait 30 seconds and then try to add the device again.
Socket connected to the hub will appear in the list of devices of the hub in the application. Update of the detector
statuses in the list depends on the device inquiry time set in the hub settings, with the default value – 36 seconds.
States
1. Devices
2. Socket
To Next Page
Loading...
Need help?
General
