• Users — define who has access to your security system, what rights are granted to them, how the hub notifies of
events.
• Ethernet — configure the Ethernet connection.
• GSM — switch on/off cellular communication, configure the connection and check the balance.
• Geofence — set the reminder of arming/disarming the security system, when entering the specified area.
The user location is determined based on the data from the GPS antenna or iBeacon (only for Apple devices).
• Groups — open group mode settings.
• Security Schedule — set a schedule to arm/disarm the security system automatically.
• Detection Zone Test — run the detection zone test for the connected devices.
• Jeweller — configure the hub-detector ping interval and number of undelivered packets that determines connection
failure.
The ping interval determines how frequently the devices communicate. The shorter interval (in seconds) means
faster delivery of the events between the hub and the connected devices. The number of undelivered packets
determines how quickly the hub identifies the connection loss with the device.
Calculation of the time for raising the alarm (with the default parameters):
(8 packets + 1 corrective) × 36 seconds inquiry interval = 5 minutes 24 seconds
To Next Page
Loading...
Need help?
General
