In any case, alarms are transmitted immediately. Keep in mind that the ping interval can reduce the maximum
number of connected devices:
• Service — opens service settings of the hub.
Connection Failure Alarm Delay — regulates the alarm notification delay of the server connection loss.
Server Ping Interval — regulates the interval of sending pings from the hub to the server.
Time for generation of the message of the connection loss between the server and the hub is calculated as follows
(with the default parameters):
(3 pings + 1 corrective) × 60 seconds inquiry interval + 300 seconds time filter = 9 minutes.
You can disable hub firmware auto-update (enabled by default).
How to turn off hub firmware auto-update
• Monitoring Station — configure CMS connection settings.
• PRO — configure PRO-accounts connected to the hub.
To Next Page
