The system or the group is
switched to the Night Mode.
The built-in buzzer emits a
short beep.
If notications for Night Mode
Activation/Deactivation are
enabled.
The system is disarmed.
The built-in buzzer emits two
short beeps.
If notications for
Arming/Disarming are
enabled.
System in the armed mode.
The LED indicator lights up red
for a short time every 3
seconds if the external power
is not connected.
The LED indicator constantly
lights up red if the external
power is connected.
If Armed Mode Indication is
enabled.
The indication turns on when
the keypad switches to sleep
mode (the display goes out).
An incorrect code was
entered.
An appropriate notication is
shown on the display.
The built-in buzzer emits a
short beep (if adjusted).
The beep loudness depends
on the congured buttons’
volume.
Error when adding a card/key
fob.
An appropriate notication is
shown on the display.
The LED indicator lights up red
once.
The built-in buzzer emits a
long beep.
The beep loudness depends
on the congured buttons’
volume.
Successfully added card/key
fob.
An appropriate notication is
shown on the display.
The built-in buzzer emits a
short beep.
The beep loudness depends
on the congured buttons’
volume.
Low battery.
The LED indicator smoothly
lights up and goes out when
the tamper is triggered, an
alarm is activated, or the
system is armed or disarmed
(if the indication is activated).
Tamper triggering.
The LED indicator lights up red
for 1 second.
Jeweller/Wings Signal
Strength Test.
The LED indicator lights up
green during the test.
Turns on after launching an
appropriate test in the