KeyPad TouchScreen indication is shown on the display only when it is active.
Icons that indicate some system or keypad states are displayed in the upper
part of the Control tab. For example, they can indicate re alarm, system
restoration after alarm, and chime on opening. Information about the security
mode will be updated, even if it is changed by another device: key fob, other
keypad or in app.
Event Indication Note
Alarm.
The built-in buzzer emits an
acoustic signal.
If Activate keypad buzzer if
alarm in the system is
detected toggle is enabled.
The duration of the acoustic
signal depends on the keypad
settings.
An alarm was detected in the
armed system.
The LED indicator blinks twice
approximately every 3 seconds
until the system is disarmed.
To activate, enable the
in the
hub settings. Also, specify
KeyPad TouchScreen as a
device for informing about
other devices’ alarms.
The indication turns on after
the built-in buzzer completely
plays the alarm signal.
Switching on the
device/Loading the updated
system conguration to the
keypad.
An appropriate notication is
shown on the display while the
data is loading.
Switching off the device.
The LED indicator lights up for
1 second, then blink three
times.
The system or the group is
armed.
The built-in buzzer emits a
short beep.
If notications for
Arming/Disarming are
enabled.
To Next Page
Loading...
Need help?
General
