A.9
STARTING OFF
Press the clutch lever and put the engine in first gear. Slowly release the clutch lever and open the throttle at the same time.
USING THE GEARBOX
The first gear is referred as the start off or uphill gear. Depending on the conditions (traffic, surface inclination, etc.) you should shift to the
suitable gear. To shift between gears, simultaneously close throttle and operate the clutch lever, then use the gearshift pedal to switch gears.
High rpm rates in a cold engine will reduce the engine lifetime. We recommend to run the engine in moderate rpm on first 10 km
(6 miles), giving it the chance to warm up.
Never shift down gears with throttle wide open. The engine will over-rev, damaging the valves and the gearbox.
If any abnormal vibrations occur while driving, check for loosen bolts in the engine. If the vibration remains contact an AJP dealer.
If you notice any unusual operation-related noise while riding, stop immediately. Shut the engine off and contact an AJP dealer.
Never start your motorcycle without air filter placed, otherwise dust and dirt may penetrate the engine creating premature wear
or damaging it.
To Next Page
Loading...
