The AJP PR7 model is equipped with a fully adjustable shock absorber.
To adjust the preload:
― Loose the upper nut (1);
― Turn the adjusting nut (2) clockwise for more preload.
Turn the adjusting nut (2) counter-clockwise for less preload.
In order to adjust the rebound :
― Rotate screw (3) clockwise to decrease the rebound speed.
― Rotate screw (3) counter-clockwise to increase rebound speed.
To adjust low or fast compression damping, rotate the screw (4) and adjuster (5) respectively.
― To decrease the compression speed, turn clockwise.
― To increase the compression speed, turn counter-clockwise.
Improper servicing of the rear shocks absorber is dangerous. The rear shock contains
high-pressure gas and can explode when handled improperly.
Standard settings
Rebound: Turn counter-clockwise (S) until make 14 clicks from the closed position.
Low compression: Turn 12 clicks counter-clockwise (-) from the closed position.
Fast compression: Turn 10 clicks counter-clockwise (-) from the closed position.
To Next Page
Loading...
