CHECKING FRONT BRAKE PADS
The front brake pads can be inspected through the spokes on the opposite side of the brake
system, as showed in the picture. The linings must have at least 1mm thickness.
At their most worn point, brake pad linings should not be thinner than 1mm,
otherwise can lead to braking failure.
The rear brake pads can be inspected from the rear side of the motorcycle. The linings cannot
have less than 1mm thickness.
If brake pads are replaced too late, steel components of brake pad will rub against
brake disc. Thereby, braking effect will be reduced and destroying the brake disc.
To Next Page
Loading...
