AJP PR7 - Replacing Main Oil Filter

D.5
ENGINE
Note: We recommend that oil filters
maintenance should be performed by an
authorized AJP dealer.
REPLACING MAIN OIL FILTER
The main oil filter is located in right side of the crankcase. This component retains the dust and
metallic particles, requiring periodically maintenance.
― Remove the engine oil (see CHANGING ENGINE OIL);
― Unscrew the screws (1) of the oil filter cover;
― Remove the oil filter cover (2);
― Remove the main oil filter (3) with a plier;
― Replace the main oil filter;
― Clean the oil filter cap with compressed air;
― Inspect the seal (O-ring) and replace if necessary;
― Install the main oil filter with hole end pointing to inside of the crankcase;
― Assembly the oil filter cover with the respective string and tight the screws;
― Remove oil filler cap and fill with 1,7 liters of recommended engine oil;
― Start the engine and let it on idle for about two minutes;
― Check leaks and the oil level, refill if necessary.
Main oil filter cover bold (1) torque: 9,3 N.m (0.95 Kgf.m)
WARNING
Avoid damaging the engine due insufficient lubrication. It is important to assure the
correct position of the main oil filter.
1
1
2
3