AJP PR7 - Brake Disc

D.15
BRAKE SYSTEM
BRAKE DISC
Due to wear, the thickness of brake discs in the contact area of the brake pads starts to
decrease. At their thinnest point (2), the brake discs shall not be less than 0.50mm thinner than
nominal thickness. Measure the nominal thickness in the zone (1) outside of contact area and
check for wear in several points.
DANGER
For your own safety replace the brake discs as soon as they reach wear limit (3.8
mm for the front disc and 4.5 mm for the rear disc).
Any repair on brake system should be performed by an authorized AJP dealer.
BRAKE DISC
The sintered brake pads used on the PR7 front and rear brake systems provide an optimal
combination of brake power, performance and lifecycle.
1
2