1
1. INTRODUCTION
Aksa Generator set is designed to be commissioned,
when delivered, as soon as the necessary cooling wa-
ter, antifreeze, fuel, lubrication oil and fully charged bat-
tery are provided.
With its long years of experience, Aksa manufactures
efficient, reliable and quality generator set.
This operating and maintenance manual is prepared
to assist the operator in operation and maintenance
of the generator set. Observing the advices and rules
in this manual will ensure that the generator set op-
erates in maximum performance and efficiency for a
long time.
1. Care should be taken to perform more frequent
maintenance in dirty and dusty environments in order
to keep the generator set in good working condition.
2. Necessary adjustment and repairs should be made
only by authorized and qualified persons.
3. Each generator set has a model and a serial num-
ber indicated on a label on the base frame. This plate
also indicates the manufacturing date, voltage, current,
power in kVA and kW, frequency, power factor and
weight of the generator set. These data are necessary
in spare part orders, for warranty validity and for ser-
vice calls.
4. Make sure that recommended oil ,fuel and coolant
are used.
5. Call Aksa service in any case.
6. Take installation and safety precautions.
7. GenSets are produced according to ISO8528 stand-
ard.
8. AAP12000E and AAP12000E3 genset is not de-
signed for outdoor use. Because of lack of noise atten-
uation, gensets shouldn’t be use in an ambience like
under tents, under roofs for protection against rain etc.
Figure 1.1. Aksa Generator Set Data plate
1.1 Diesel GenSet and its Equipments
Diesel Gensets and their standard equipments are sent
from the factory on trucks. Open portative type and
canopy type GenSet’s equipments are mentioned be-
low.
• Diesel engine and alternator are mounted on the
base frame via anti vibration mounting (AVM).
• Engine mounted radiator and fan. Base frame in-
cludes a fuel tank.
• Fuel pipes.
• Batteries, battery stand and connection cables.
• Industrial type exhaust silencer mounted on the
Genset.
• Wheels (optional). Automatic Control Panel.
Gensets are ready to use. Genset will be ready to run
after its oil, coolant and fuel are filled and power cables
are provided and then connected. Load output con-
nection is socket type in open Gensets, and terminals
in the control panel, are used in canopy type Gensets.
First Start
First start has to be done by authorized person from
Aksa service, otherwise the warranty will be invalid.
After all connection and checks are done by author-
ized Aksa service, Genset will be run and given in to
the customer.
1.2 .Receipt of the Genset
When you have received the Genset, check the Gen-
set to see whether it’s in good condition or not and
all equipments are given or mounted. If the Genset
won’t be used for a while, it has to be stored in a good
storage.
Warning;
if you see any missing or broken parts during the deliv-
ery, not all this into transportation receipt and make it
signed by carrier ,if missing or broken parts are found
after receipt, spare them and contact the transporta-
tion company for complaint procedure. Missing and
damaged parts are not in warranty.
1.3. Installation that should be done by customer
Transportation and installation of the Genset and its
equipments are customer responsibility.
Aksa or Aksa authorized service offer turnkey project
according to customer requirement after doing neces-
sary exploration.
To Next Page
Loading...
