8
emission from engine and can direct exhaust gases to
safe outlets.
3.10. Control System
One of several types of control systems and panels
(item 12) may be fitted to control the operation and
output of the set and to protect the set from pos-
sible malfunctions. Section 11 of this manual provides
detailed information on these systems and will aid in
identification of the control system fitted on the gen-
erator set
4-MAIN TECHNICAL SPECIFICATIONS AND DATA
Table 4.1. Technical Specification
5. INSTALLATION
Once the size of the generator set and any associated
control systems or switchgear have been established,
plans for installation can be prepared. This section dis-
cusses factors important in effective and safe installa-
tion of the generator set.
5.1. Moving the Generator Set
The generator set base frame is specifically designed
for ease of moving the set. Improper handling can se-
riously damage components. Using for a forklift, the
generator set can be lifted or carefully pushed/pulled
by the base frame directlywith fork.
Figure 5.1. Lifting generator set by using a winc
Warning
• Never lift the generator set by attaching to the en-
gine or alternator lifting lugs.
• Always use wood between forks and the base frame
to spread the load and prevent damage.
• Ensure the lifting rigging and supporting structure is in
good condition and is suitably rated.
2,3
6,4
15
4
12V DC
A2CRX08
MODEL
Rated Frequency
Rated Power
Max Power
Rated Voltage*
Rated Ampera
Rated Speed
Phase
Power Factor(cos )
Excition Mode
Structure Mode
Oil Capacity
Coolant Capacity
Fuel Tank Capacity
Fuel Consumption (Prime)
Start System
Gross Weight
Dimention (LxWxH)
Engine Model
APD 12E
50
11 kVA
12 kVA
400/230
16
3000
Üç faz
0,8
Transformer
with Brush
250
APD12EM
50
9,6 kWe
8,8 kWe
230
38
3000
Tek faz
1
Capacitor,
Brushless
250
(Hz)
(V)
(A)
(rpm)
L
L
L
L/hr
(kg)
(mm)
Silence Type
1152 x 776 x 890
To Next Page
Loading...
