Akuvox C313 Series Admin Guide

C313X Indoor Monitor Administrator Guide
AKUVOX SMART INTERCOM www.akuvox.com
67
 Zone Type: set up the alarm sensor types. You can select among four
sensor types: “Infrared”, “Drmagnet”, “Smoke”, “Gas”, “Urgency”.
 Trigger Mode: set sensor trigger mode between “NC” and “NO” according
to your need.
 Status: set the alarm sensor status among three options: “Enable”,
“Disable”,”24H”. Select “Enable” if you want to enable to the alarm,
however you are required to set the alarm again after an alarm is
disarmed. Select “Disable” if you want to disable the alarm and select
“24H” if you want alarm sensor to stay enabled for 24 hours without
needing to set up the alarm manually again after the alarm is disarmed.
14.2.3. Configure Location-based Alarm on the device
screen
Configure the location-based alarm on device screen Arming > Arming mode.

Akuvox C313 Series Specifications

General

Audio	Built-in Microphone and Speaker
Installation	Wall-mounted
Ethernet	10/100Mbps
Relay Output	1
PoE	IEEE 802.3af
Power Supply	DC 12V or PoE