Akuvox C313W - Configure Location-Based Alarm on the Web Interface

C313X Indoor Monitor Administrator Guide
AKUVOX SMART INTERCOM www.akuvox.com
68
Parameters set up:
 Location: to display which location the detection device is located.
 Zone type: to display the type of detection device.
 Defence delay: it means when users enable the arming mode, there will
be 90 seconds delay time for the alarm mode to be activated.
 Alarm delay: it means when the sensor triggered, there will be 90
seconds delay time to announce the notification.
 Status: To enable or disable Arming mode on the corresponding Zone.
14.2.4. Configure Location-based Alarm on the Web
Interface
Configure the location-based alarm on device web interface Arming > Arming
Mode.