Alcatel-Lucent 7750 SR OS - Configuring Physical Ports with CLI

Interface Configuration
7750 SR OS Interface Configuration Guide Page 141
Configuring Physical Ports with CLI
This section provides information to configure cards, MDAs, and ports.
Topics in this section include:
• Preprovisioning Guidelines on page 143
→ Predefining Entities on page 143
→ Preprovisioning a Port on page 144
→ Maximizing Bandwidth Use on page 145
• Basic Configuration on page 146
• Common Configuration Tasks on page 148
→ Configuring Ports on page 155
• Common Configuration Tasks on page 148
→ Configuring Cards and MDAs on page 149
→ Configuring Cards, MDA Carrier Modules (MCMs) and Media Dependent Adapters
(MDAs) on page 150
− Configuring MDA/CMA Access and Network Pool Parameters on page 153
→ Configuring Ports on page 155
− Configuring Port Pool Parameters on page 155
− Changing Hybrid-Buffer-Allocation on page 158
− Configuring APS Parameters on page 159
− Configuring Ethernet Port Parameters on page 161
− Configuring SONET/SDH Port Parameters on page 164
− Configuring Channelized Ports on page 167
− Configuring Cpipe Port Parameters on page 187
− Configuring ATM SAPs on page 189
− Configuring DWDM Port Parameters on page 190
− Configuring OTU Port Parameters on page 195
− Configuring ATM Interface Parameters on page 197
− Configuring Frame Relay Parameters on page 202
− Configuring Multilink PPP Bundles on page 206
− Configuring Multilink ATM Inverse Multiplexing (IMA) Bundles on page 207
− Configuring Bundle Protection Group Ports on page 212
→ Configuring LAG Parameters on page 217