Alcatel-Lucent 7750 SR OS - SONET; SDH Path Attributes; Table 5: Valid SONET and SDH Path Configurations

Interface Configuration
7750 SR OS Interface Configuration Guide Page 39
if no power is present. The status LED is green when operationally up, amber when operationally
down, off when administratively shutdown and blinking green during initialization. The link state
LED is green when the link is established; amber when the link is down; and unlit when the port is
shutdown.
SONET/ SDH Path Attributes
Any CES path can only be configured to operate in access mode. Each path has a configurable text
description. The SONET/SDH signal label byte (C2) is configurable. The SONET/SDH path trace
string (J1) is configurable. Payload scrambling can not be enabled on CES paths. The valid
SONET and SDH path configurations are shown in Table 5.
All SONET/SDH path alarms are configurable to be either enabled (the default) or disabled. The
MTU size is configurable per path in the range of 512 to 2092. The path uses a default MTU size
set to equal the largest possible CES packet size.
Load balancing options are not applicable to channelized CES paths.
Table 5: Valid SONET and SDH Path Configurations
Framing Path Configuration Options
Per Physical Port
Max Number of Paths Per Physical Port
SDH STM1>AUG1>VC4>TUG3>TUG2>VC12>
E1 STM1>AUG1>VC3>TUG2>VC12>E1
63 E1 or 512 n*64kbps
SONET OC3>STS1 SPE>DS3>E1
SONET OC3>STS1 SPE>VT GROUP>VT1.5
SPE>DS1
84 DS1 or 512 n*64kbps
SONET OC3>STS1 SPE>DS3 3 DS3
SONET OC3>STS1 SPE>DS3>DS1 84 DS1, 63 E1 or 512 n*64kbps
SDH STM1>AUG1>VC4>TUG3>TUG2>TU11>
VC11>DS1
STM1>AUG1>VC3>TUG2>VC11>DS1
84 DS1 or 512 n*64kbps
SDH STM1>AUG1>VC3>DS3>DS1 84 DS1, 63 E1 or 512 n*64kbps
SDH STM1>AUG1>VC4>TUG3>VC3>E3
STM1>AUG1>VC3>E3
3 E3
SDH STM1>AUG1>VC3>DS3 3 DS3
SDH STM1>AUG1>VC3>DS3>E1 3 DS3