Alcatel-Lucent 7750 SR OS - ATM Interface Configurations

Configuring Ports
Page 200 7750 SR OS Interface Configuration Guide
ATM Interface Configurations
Use the following CLI syntax to configure ATM interface parameters for SONET/SDH paths:
CLI Syntax: config# port port-id
sonet-sdh
path [sonet-sdh-index]
atm
cell-format cell-format
ilmi [vpi/vci]
egress
traffic-desc traffic-desc-profile-id
ingress
traffic-desc traffic-desc-profile-id
keep-alive [poll-frequency seconds] [poll-
count value] [test-frequency seconds]
protocol protocol-type
[no] shutdown
min-vp-vpi value
Use the following CLI syntax to configure ATM interface parameters for IMA bundles.
CLI Syntax: config>port>multilink-bundle
ima
atm
cell-format cell-format
min-vp-vpi value
Use the following CLI syntax to configure ATM interface parameters for TDM channels:
CLI Syntax: config# port {port-id}
tdm
ds1 [ds1-id]
channel-group 1
atm
cell-format cell-format
min-vp-vpi value
ds3 [sonet-sdh-index]
atm
cell-format cell-format
min-vp-vpi value
mapping {direct | plcp}
e1 [e1-id]