Alcatel-Lucent 7750 SR OS - Page 187

Interface Configuration
7750 SR OS Interface Configuration Guide Page 187
Configuring Cpipe Port Parameters
Before a Cpipe service can be provisioned, the following entities must be configured.
• Configuring a DS1 Port on page 187
• Configuring a Channel Group on page 187
Configuring a DS1 Port
The following displays an example of a DS1 port configured for CES.
A:sim216# show port 1/5/1.1.3.1
===============================================================================
TDM DS1 Interface
===============================================================================
Description : DS1
Interface : 1/5/1.1.3,1
Type : ds1 Framing : esf
Admin Status : up Oper Status : up
Physical Link : yes Clock Source : loop-timed
Signal Mode : none
Last State Change : 10/31/2006 14:23:12 Channel IfIndex : 580943939
Loopback : none Invert Data : false
Remote Loop respond: false In Remote Loop : false
Load-balance-algo : default Egr. Sched. Pol : n/a
BERT Duration : N/A BERT Pattern : none
BERT Synched : 00h00m00s Err Insertion Rate : 0
BERT Errors : 0 BERT Status : idle
BERT Total Bits : 0
Cfg Alarm : ais los
Alarm Status :
===============================================================================
A:sim216#
Configuring a Channel Group
The following displays an example of a DS1 channel group configured for CES.
A:sim216# show port 1/5/1.1.3.1
===============================================================================
TDM DS0 Chan Group
===============================================================================
Description : DS0GRP
Interface : 1/5/1.1.3.1
TimeSlots : 1-12
Speed : 64 CRC : 16
Admin Status : up Oper Status : up
Last State Change : 10/31/2006 14:23:12 Chan-Grp IfIndex : 580943940
Configured mode : access Encap Type : cem
Admin MTU : 4112 Oper MTU : 4112