Interface Configuration
7750 SR OS Interface Configuration Guide Page 279
For line alarms, separately, modify the 2 physical ports that are members of the logical aps-id
port (the working and protect lines). APS reacts only to line alarms, not path alarms.
For example:
configure port 1/2/3 sonet-sdh report-alarm lb2er-sd
configure port 1/3/4 sonet-sdh report-alarm lb2er-sd
For example:
A:ALA-48>config>port>aps# info
----------------------------------------------
working-circuit 1/2/3
protect-circuit 1/3/4
----------------------------------------------
A:ALA-48>config>port>aps#
If the SD and SF threshold rates must be modified, the changes must be performed at the line
level on both the working and protect APS port member.
The no form of this command deletes an aps-group-id or bundle-aps-group-id. In order for an
aps-group-id to be deleted,
The same rules apply for physical ports, bundles deletions apply to APS ports/bundles deletions
(for example an aps-group-id must be shutdown, have no service configuration on it, and no path
configuration on it). In addition working and protection circuits must be removed before an aps-
group-id may be removed.
Syntax: port aps-group-id
aps:keyword
group-id: 1 — 16
Example: port aps-16
ddm-events
Syntax [no] ddm-events
Context config>port
Description This command enables Digital Diagnostic Monitoring (DDM) events for the port.
The no form of the command disables DDM events.
dwdm
Syntax dwdm
Context config>port
Description This command configures the Dense Wavelength Division Multiplexing (DWDM) parameters.
To Next Page
Loading...
