Alcatel-Lucent 7750 SR OS - Page 296

Configuration Commands
Page 296 7750 SR OS Interface Configuration Guide
statistics and the data will be received error free. If the port is configured for synchronous mapping
and the received data is asynchronously mapped, there will be errors in the received data.
The no form of this command configures the port to receive synchronously mapped data.
Default no async-mapping
report-alarms
Syntax [no] no report-alarms [loc] [los] [lof] [lom] [otu-ais] [otu-ber-sf] [otu-ber-sd] [otu-bdi]
[otu-tim] [otu-iae] [otu-biae] [fec-sf] [fec-sd] [fec-fail] [fec-uncorr] [odu-ais] [odu-oci]
[odu-lck] [odu-bdi] [odu-tim] [opu-tim] [opu-plm]
Context config>port>otu
Description This command enables OTU alarms. Specify specific alarms to add to the list of reported alarms.
The no form of the command disables OTU alarm reporting.
Default loc, los, lof, lom, otu-ais, otu-bdi, fec-sf, fec-sd, odu-ais, odu-oci, odu-lck, odu-bdi, opu-plm
Parameters alarms — Refer to the following table for alarm descriptions.
Alarm Description
loc
Loss of lock
los
Loss of signal transitions on the data
lof
Loss of OTU framing
lom
Loss of Multi-frame
otu-ais
OTU Alarm Indication Signal (all 1s, overwrites all OTU overhead, even
framing bytes)
otu-ber-sf
SM Signal Fail (based on BPI8)
otu-ber-sd
SM Signal Degrade (based on BPI8)
otu-bdi
SM Backward defect indication
otu-tim
SM Trace Id Mismatch
otu-iae
SM Incoming Alignment Error
otu-biae
SM Backward Incoming Alignment Error
fec-sf
Signal Fail (based on FEC corrected bits)
fec-sd
Signal Degrade (based on FEC corrected bits)
fec-fail
FEC Mode mismatch (EFEC-GFEC) or High Uncorrectable rate (>10E-2)
fec-uncorr
One or More Uncorrectable FEC errors
odu-ais
ODU Alarm Indication Signal