Interface Configuration
7750 SR OS Interface Configuration Guide Page 345
quiet-period
Syntax quiet-period seconds
no quiet-period
Context config>port>ethernet>dot1x
Description This command configures the period between two authentication sessions during which no EAPOL
frames are sent by the 7750 SR.
The no form of this command returns the value to the default.
Default 30
Parameters seconds — Specifies the quiet period in seconds.
Values 1 — 3600
radius-plcy
Syntax radius-plcy name
no radius-plcy
Context config>port>ethernet>dot1x
Description This command configures the RADIUS policy to be used for 802.1x authentication. An 802.1x
RADIUS policy must be configured (under config>security>dot1x) before it can be associated to a
port. If the RADIUS policy-id does not exist, an error is returned. Only one 802.1x RADIUS policy
can be associated with a port at a time.
The no form of this command removes the RADIUS policy association.
Default no radius-plcy
Parameters name — Specifies an existing 802.1x RADIUS policy name.
re-auth-period
Syntax re-auth-period seconds
no re-auth-period
Context config>port>ethernet>dot1x
Description This command configures the period after which re-authentication is performed. This value is only
relevant if re-authentication is enabled.
The no form of this command returns the value to the default.
Default 3600
Parameters seconds — The re-authentication delay period in seconds.
To Next Page
Loading...
