Configuration Commands
Page 350 7750 SR OS Interface Configuration Guide
notification
Syntax [no] notification
Context config>port>ethernet>lldp>dstmac
Description This command enables LLDP notifications.
The no form of the command disables LLDP notifications.
tx-mgmt-address
Syntax tx-mgmt-address [system]
no tx-mgmt-address
Context config>port>ethernet>lldp>dstmac
Description This command specifies which management address to transmit.
The no form of the command resets value to the default.
Default no tx-mgmt-address
Parameters system — Specifies to use the system IP address. Note that the system address will only be
transmitted once it has been configured if this parameter is specified.
tx-tlvs
Syntax tx-tlvs [port-desc] [sys-name] [sys-desc] [sys-cap]
no tx-tlvs
Context config>port>ethernet>lldp>dstmac
Description This command specifies which LLDP TLVs to transmit. The TX TLVS, defined as a bitmap, includes
the basic set of LLDP TLVs whose transmission is allowed on the local LLDP agent by the network
management. Each bit in the bitmap corresponds to a TLV type associated with a specific optional
TLV. Organizationally-specific TLVs are excluded from the this bitmap.
There is no bit reserved for the management address TLV type since transmission of management
address TLVs are controlled by another object.
The no form of the command resets the value to the default.
no tx-tlvs
Parameters port-desc — Indicates that the LLDP agent should transmit port description TLVs.
sys-name — Indicates that the LLDP agent should transmit system name TLVs.
sys-desc — Indicates that the LLDP agent should transmit system description TLVs.
sys-cap — Indicates that the LLDP agent should transmit system capabilities TLVs.
To Next Page
Loading...
